Info

Facts about the machine: Interface: USB1.0 32 bit ARM7 CPU,1MB highway CACHE memory Max cutting speed: 400mm/s Cutting Force: 0 - 600g Repeatability: <+- 0.1mm Mechanical Resolution: 0.025mm/step PWM,Micro-step driver Command Set: DMPL / HPGL Manual: PCut CR-Models manual Contact: Creation Mechanical & Electrical

Plotter Setup

Before trying to get things working, determine the following:

• Attach USB-cable to your machine and insert the supplied CD and follow the new hardware wizard. (see the manual for more information)
• Check what baudrate the cutter is setup to use.
• Check that the cutting-head is not against any of the red- buttons.
• Make sure the machine is powered on and in online-mode.

Now you are ready to go to setup SignCut, click the tab for your operating system above.

SignCut Windows Setup

To setup SignCut for your machine, follow these steps:

• Open SignCut Productivity Pro.
• Click on the Cutter-button to open that dialogue.
• In the Manufacturer list, choose "Creation".
• In the Cutter list, choose your particular model.
• In the Device list, choose your device that should be a COM-port.
• Now choose the same baudrate as was set on the cutter.
• There is an option to calibrate your cutter, do NOT click there before first cut.
• Now click Ok to close the dialogue.
• Now you are ready to start cutting.

SignCut Mac Setup

To setup SignCut for your machine, follow these steps:

• Open SignCut Productivity Pro.
• Click on the Cutter-button to open that dialogue.
• In the Manufacturer list, choose "Creation".
• In the Cutter list, choose your particular model.
• In the Device list, choose your device that begins with "/dev/cu."
• Now choose the same baudrate as was set on the cutter.
• There is an option to calibrate your cutter, do NOT click there before first cut.
• Now click Ok to close the dialogue.
• Now you are ready to start cutting.