|
Setup a Seikitech plotter with SignCut |
 |
 |
 |
Click the tabs below in order to see all pages.
|
Facts about the machine:
- Serial (RS-232C)
- Cutting Speed: 10-800mm/s
- Cutting Force: 10g-500g
- Mechanical Resolution: 0.001"
- Stepper Motor
- Command Set: DMPL / HPGL
- Contact: Seiki Tech
|
|
Before trying to get things working, determine the following:
- Check what baudrate the cutter is setup to use.
- Make sure the machine is powered on and in online-mode.
Now you are ready to go to setup SignCut, click the tab for your operating system above.
To setup SignCut for your machine, follow these steps:
- Open SignCut Productivity Pro.
- Click on the Cutter-button to open that dialogue.
- In the Manufacturer list, choose "SeikiTech".
- In the Cutter list, choose your particular model.
- In the Device list, choose your device that is either a COM-port.
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
To setup SignCut for your machine, follow these steps:
- Open SignCut Productivity Pro.
- Click on the Cutter-button to open that dialogue.
- In the Manufacturer list, choose "SeikiTech".
- In the Cutter list, choose your particular model.
- In the Device list, choose your device that begins with "/dev/cu.", this requires that you have an USB to serial adapter.
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
|
