|
Setup a Creation PCut CS plotter with SignCut |
 |
 |
 |
Click the tabs below in order to see all pages.
|
Facts about the machine:
- Standard RS232(serial)/USB2.0
- Arm7(32 bit CPU)
- Max cutting speed: 1000mm/s
- Cutting Force: 0 - 500g
- Repeatability: <+- 0.1mm
- Mechanical Resolution: 0.025mm/step
- DC servo driver
- Command Set: DMPL / HPGL
- Contact: Creation Mechanical & Electrical
|
|
Before trying to get things working, determine the following:
- Decide what interface to use, and make sure to use the correct cables.
- If using USB, install the USB-driver from the supplied CD.
- Check what baudrate the cutter is setup to use.
- Check that the cutting-head is not against any of the red buttons.
- Make sure the machine is powered on and in online-mode.
Now you are ready to go to setup SignCut, click the tab for your operating system above.
To setup SignCut for your machine, follow these steps:
- Open SignCut Productivity Pro.
- Click on the Cutter-button to open that dialogue.
- In the Manufacturer list, choose "Creation".
- In the Cutter list, choose your particular model.
- In the Device list, choose your device that should be a COM-port or "Creation USB" for the USB-cable.
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
To setup SignCut for your machine, follow these steps:
- Open SignCut Productivity Pro.
- Click on the Cutter-button to open that dialogue.
- In the Manufacturer list, choose "Creation".
- In the Cutter list, choose your particular model.
- In the Device list, choose your device that begins with "/dev/cu.", or "Creation USB" for the USB-cable.
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
|
Plotter setup with SignCut