|
Setup a Creation PCut CR plotter with SignCut |
 |
 |
 |
Click the tabs below in order to see all pages.
|
Facts about the machine:
- Interface: USB1.0
- 32 bit ARM7 CPU,1MB highway CACHE memory
- Max cutting speed: 400mm/s
- Cutting Force: 0 - 600g
- Repeatability: <+- 0.1mm
- Mechanical Resolution: 0.025mm/step
- PWM,Micro-step driver
- Command Set: DMPL / HPGL
- Manual: PCut CR-Models manual
- Contact: Creation Mechanical & Electrical
|
|
Before trying to get things working, determine the following:
- Attach USB-cable to your machine and insert the supplied CD and follow the new hardware wizard. (see the manual for more information)
- Check what baudrate the cutter is setup to use.
- Check that the cutting-head is not against any of the red- buttons.
- Make sure the machine is powered on and in online-mode.
Now you are ready to go to setup SignCut, click the tab for your operating system above.
To setup SignCut for your machine, follow these steps:
- Open SignCut Productivity Pro.
- Click on the Cutter-button to open that dialogue.
- In the Manufacturer list, choose "Creation".
- In the Cutter list, choose your particular model.
- In the Device list, choose your device that should be a COM-port.
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
To setup SignCut for your machine, follow these steps:
- Open SignCut Productivity Pro.
- Click on the Cutter-button to open that dialogue.
- In the Manufacturer list, choose "Creation".
- In the Cutter list, choose your particular model.
- In the Device list, choose your device that begins with "/dev/cu."
- Now choose the same baudrate as was set on the cutter.
- There is an option to calibrate your cutter, do NOT click there before first cut.
- Now click Ok to close the dialogue.
- Now you are ready to start cutting.
|
