Info

Facts about the machine: Two connectivity options: Parallel, Serial Serial and Parallel cable included USB connection is accomplished through a USB to serial adapter. Capacity: 64Mb Max Speed: 800mm/s Max Force: 500g Repeatability: within 0.02mm Mechanical Resolution: 0.025mm/step Stepper Motors Command Set: HPGL Contact: Copam Electronic

Plotter Setup

Before trying to get things working, determine the following:

• Decide what interface to use, and make sure to use the correct cables.
• Check what baudrate the cutter is setup to use.
• Make sure the machine is powered on and in online-mode.

Now you are ready to go to setup SignCut, click the tab for your operating system above.

SignCut Windows Setup

To setup SignCut for your machine, follow these steps:

• Open SignCut Productivity Pro.
• Click on the Cutter-button to open that dialogue.
• In the Manufacturer list, choose "Copam".
• In the Cutter list, choose your particular model.
• In the Device list, choose your device that is either a COM-port or LPT-port.
• Now choose the same baudrate as was set on the cutter.
• There is an option to calibrate your cutter, do NOT click there before first cut.
• Now click Ok to close the dialogue.
• Now you are ready to start cutting.

SignCut Mac Setup

To setup SignCut for your machine, follow these steps:

• Open SignCut Productivity Pro.
• Click on the Cutter-button to open that dialogue.
• In the Manufacturer list, choose "Copam".
• In the Cutter list, choose your particular model.
• In the Device list, choose your device that begins with "/dev/cu.", for this to work you need a USB to serial adapter, we recommend keyspan.
• Now choose the same baudrate as was set on the cutter.
• There is an option to calibrate your cutter, do NOT click there before first cut.
• Now click Ok to close the dialogue.
• Now you are ready to start cutting.